It mounts directly to the bench in front of the grinder and can be readily folded out of the way for freehand grinding. The 4" wide table straddles wheels up to 1" wide. It is grooved for sliding jigs and center drilled for rotating jigs. The slotted arms allow a wide range of angular and height adjustments. Spring-loaded gyratory handles lock it solidly in position and can be rotated out of the way after locking.
You can easily move it from one grinder to another or quickly remove it from the bench. Accurately machined, anodized aluminum construction. It is completely compatible with the Veritas grinding jig and skew-grinding jig.
Product Added To WishList. QTY: 0. Put a tool in the jig, slide it against the alignment pin and one clamping thumbscrew to square it, adjust the blade projection for bevel angle, and tighten in place. The tool is now held squarely in the jig at the chosen bevel angle. Slide the jig back and forth across the tool rest and stone face to sharpen the tool.
The back plate is offset for short chisels, such as Japanese or western butt chisels. The brass clamping bolts have nylon washers to prevent galling; other parts are made from hard aluminium, further hardened by anodizing to prevent wear.
High-friction pads ensure solid clamping without inadvertent misalignment. The jig fits in the slot of the Veritas grinder tool rest no. This solid, cast iron holdfast is essential for any workbench. Instead of Clamping depth mm Instead of Use on 6" and 8" grinders and belt sanders Angle setting gauge included. I bought this for use on a RPM bench grinder and it is a great tool. The included instructions make setting it up seem daunting but there is quite a bit of leeway when it comes to getting an accurate angle, so it is quite forgiving.
The most useful and simple additon to my shop. Freehand grinding of high-end chisels and blades was always a worry for me, now this is a straight forward easy operation with great results. Easy set up and use, produces the fine result that is required on quality tools. Very easy to install. Very easy to use. My stock tool rest was pure junk, as are most standard ones. Within minutes of installation, I was grinding perfectly square hollow ground chisel blades, and I have not even tried the accessory grinding jig yet!
I'll try that for my plane blades. Find a Store. My Account. My Cart. Go to Home Page.
0コメント